Run wash cycle
23
During the washing program
You can at any time
– change the setting of the final spin speed,
– select
(Rinse Hold),
– change the setting of the temperature.
Other settings cannot be changed.
To stop the washing program prematurely:
0
Press the
(ON/OFF) button.
0
Turn the program selector clockwise to
(PUMP OUT).
0
Press the
(ON/OFF) button again. The water is pumped out.
Washing cycle finished/Removing the washing
The washing program is completed when the
(ON/OFF) button
display lamp goes out.
After a Rinse Hold the water must first be pumped out or the washing
spun:
0
Either press the final spin speed/
(Rinse Hold) button so
often until the display of the spin speed required lights up,
or
turn the program selector clockwise to
(SPIN)
(washing is spun in accordance with the program which has just run),
or
turn the program selector clockwise to
(PUMP OUT).
(water is pumped out).
0
Open the door.
0
Remove the washing.
0
Switch off the washing machine by pressing the
(ON/OFF) button.
0
Close the tap.
0
Pull the detergent compartment out a little so that it can dry. Only lean
the door to so that the washing machine can get some air.