Instructions for use
37
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code
E20
ap-
pears. The indicator
RINSE (SPÜLEN,
RINCAGE) flashes.
Drainage hose bent.
Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for de-
livery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected: Si-
phon blocked.
Clean the siphon.
The main door cannot
be opened while the
appliance is turned on.
The main door is locked be-
cause of a high water level or
a high temperature. The dis-
play DOOR (TÜR, PORTE) is
not lit.
Wait until the display DOOR
(TÜR, PORTE) lights up green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF (AUS, ARRET); turn the
programme knob to PUMP
OUT (PUMPEN, VIDANGE).
Press button START/PAUSE .
The main door can be opened
after the water has been
pumped out.
Power failure!
(All displays have gone off.)
For safety reasons the door
remains locked for 4 to
5 minutes.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section “Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 5 minutes
the door can be opened
again by pulling the handle.
Washing detergent
residues form in the
washing detergent
drawer.
Water valve not fully opened. Open the water valve fully.
Filter in the screw connec-
tion of the intake hose on
the water valve or on the
unit is blocked.
Close the water valve. Un-
screw the intake hose from
the water tap and from the
unit. Clean the filter.
Problem
Possible Cause
Remedy
Summary of Contents for KO-LAVAMAT 74740
Page 1: ...ÖKO LAVAMAT 74740 update The Environmentally Friendly Washing Machine User Information ...
Page 52: ...52 ...
Page 53: ...53 ...