•
Do not install the appliance behind a lockable door, a
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from
being fully opened.
•
Connect the mains plug to the mains socket only at
the end of the installation process. Make sure that the
mains plug is accessible after installation.
•
The ventilation opening in the base (if applicable)
must not be covered by a carpet, mat, or any floor
covering.
•
Ensure good air ventilation in the located room to
avoid the backflow of unwanted gases into the room
from appliances burning gas or other fuels, including
open fires.
•
Exhaust air must not be discharged into a flue which is
used for exhausting fumes from any appliances
burning gas or other fuels.
•
The operating water pressure at the water entry point
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
•
Do not exceed the maximum load of 9 kg (refer to the
"Programme chart" chapter).
•
The appliance must be connected to the water mains
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
•
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
•
Wipe away lint or packaging debris that has
accumulated around the appliance.
•
Items that have been soiled with substances such as
vegetable or mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax
removers should be washed separately with an extra
amount of detergent before being dried in the washer
dryer.
www.aeg.com
4
Summary of Contents for L 87695 NWD
Page 1: ...EN User Manual Washer Dryer L87695NWD ...
Page 37: ...ENGLISH 37 ...
Page 38: ...www aeg com 38 ...
Page 39: ...ENGLISH 39 ...