10. BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is residual water left in
the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
4. Put a small quantity of detergent in
the compartment for washing phase.
5. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
11. DAILY USE
11.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press button Ein/Aus to activate the
appliance.
A short tune sounds.
11.2 Loading the laundry
1. Open the appliance lid.
2. Push the button A.
A
The drum opens automatically.
3. Put the laundry in the drum, one item
at a time.
4. Shake the items before you put them
in the appliance.
Make sure not to put too much laundry in
the drum.
5. Close the drum and the lid.
CAUTION!
Before you close the lid of
your appliance, make sure
that you close the drum
correctly.
11.3 Detergent
compartments. Using
detergent and additives
1. Measure out specified detergents and
the fabric conditioner.
2. Put the detergent and the fabric
conditioner into the proper
compartments.
Always follow the
instructions that you find on
the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum
indicated level. This quantity
will however guarantee the
best washing results.
When using liquid
detergents add them into a
dosing ball (supplied by the
detergent's manufacturer).
Put the dosing ball inside the
washing machine's drum, on
top of the garments.
www.aeg.com
20
