8.
BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is a residual water left in
the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1.
Make sure that all transit bolts have
been removed from the appliance.
2.
Make sure that the electrical power is
available and the water tap is open.
3.
Pour 2 litres of water into the
detergent compartment marked by
.
This action activates the drain system.
4.
Pour a small quantity of detergent
into the compartment marked by
.
5.
Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
9.
SETTINGS
9.1
Child Lock
With this option you can prevent that the
children play with the control panel.
• To
activate/deactivate
this option,
touch the Flecken/Vorw. and the Extra
Spülen buttons simultaneously until
the indicator
comes on/goes off
on the display.
You can activate this option:
• After you touch the Start/Pause
button: all the buttons and the
programme dial are deactivated
(except Ein /Aus button ).
• Before you touch the Start/Pause
button: the appliance cannot start.
The appliance keeps the selection of this
option after you switch it off.
9.2
Acoustic signals
This appliance is provided with different
acoustic signals, that operate when:
• You activate the appliance (special
short tune).
• You deactivate the appliance (special
short tune).
• You touch the buttons (click sound).
• You make a wrong selection (3 short
sounds).
• The programme is completed
(sequence of sounds for about 2
minutes).
• The appliance has a malfunction
(sequence of short sounds for about 5
minutes).
To
deactivate/activate
the acoustic
signals when the programme is
completed, touch the Extra Spülen and
the Zeitvorwahl buttons simultaneously
for about 6 seconds.
If you deactivate the
acoustic signals, they
continue operate when the
appliance has a malfunction.
9.3
Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a
programme where it is selectable.
• To
activate/deactivate
this option
touch the Extra Spülen button and the
Option button simultaneously the
relevant indicator
comes on/goes off
.
This option adds two rinses and the
display shows
.
9.4
Soft Plus
Set the Soft Plus option to optimise the
fabric softener distribution and improve
the fabric softness.
It is suggested when you use the fabric
softener.
ENGLISH
21
