This option increases slightly
the programme duration.
To
activate/deactivate
this option touch
the Temp. button and the U.Min. button
simultaneously until the indicator
comes on/goes off
above the
indicator.
10.
DAILY USE
WARNING!
Refer to Safety chapters.
10.1
Activating the appliance
1.
Connect the mains plug to the mains
socket.
2.
Open the water tap.
3.
Press the Ein /Aus button for a few
seconds to activate the appliance.
A short tune sounds (if activated). The
programme dial is automatically set on
Cotton programme .
The display shows the maximum load,
the default temperature, the maximum
spin speed, the indicators of the phases
making up the programme and the cycle
duration.
10.2
Loading the laundry
1.
Open the appliance door.
2.
Shake the items before you put them
in the appliance.
3.
Put the laundry in the drum, one item
at a time.
Make sure not to put too much laundry
in the drum.
4.
Close the door firmly.
CAUTION!
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage to
the laundry.
10.3
Filling the detergent and
additives
Compartment for prewash phase
an soak programme.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of
liquid additives.
Compartment for stain remover.
Flap for powder or liquid
detergent.
Always follow the
instructions that you find on
the packaging of the
detergent products, but we
recommend that you do not
exceed the maximum
indicated level (
). This
quantity will however
guarantee the best washing
results.
www.aeg.com
22