AEG L7WB86GW, User Manual

To have a good drying by

using less energy and in a

shorter time, the appliance

does not let you set a too

low spin speed for the items

to be washed and dried.

2.

Touch button Start/Pauze to start the

programme.

In the display the door locked 

indicator goes on, the indicator of the

running phase starts flashing.

The display also shows the remaining

programme time.

12.3 

Timed Drying

1.

Tap on the button Tijd repeatedly to

set the desired time value (see the

"Timed drying" table the

"Programmes" chapter). The drying

level indicator goes off and the
indicator 

 comes on.

Each time you tap on this button the

time value increases by 5 minutes. The

display shows the set new time value.

2.

Touch the Start/Pauze to start the

programme.

In the display the door locked 

indicator comes on and the indicator of

the running phase starts flashing.

The display also shows the remaining

programme time.

12.4 

At the end of the drying

programme

• The appliance stops automatically.

• The acoustic signals operate (if they

are active).

• In the display   comes on.

• The indicator of button Start/Pauze

goes off. The door locked 

 goes

off

• Press the button Aan/Uit for some

seconds to deactivate the appliance.

After some minutes from

the end of the

programme, the energy

saving function

deactivates the appliance

automatically.

1.

Remove the laundry from the

appliance.

2.

Make sure that the drum is empty.

After drying phase, clean the

drum, the seal and the inside

of the door with a wet cloth.

13. 

FLUFF IN THE FABRICS

During the washing and/or drying phase,

some types of fabric, (sponge, wool,

sweatshirt) could release fluff.
The released fluff could stick to the

fabrics during the next cycle.
This inconvenient increases with

technical fabrics.
To prevent the fluff in your laundry, we

recommend that you:
• To do not wash dark fabrics after you

washed and dried light coloured

fabrics (hand towel, wool, sweatshirt )

and the contrary.

• To dry this type of fabrics at open air

when they are washed the first time.

• To clean the drain filter.

• After the drying phase, clean the

empty drum, the gasket and the door

with a wet cloth.

To remove the fluff inside the drum,

set a special programme:

• Empty the drum.

• Clean the drum, the gasket and the

door with a wet cloth.

• Set the rinse programme.

• Simultaneously press the TPM and the

Tijd besparen buttons until the

display shows 

CLE

 to activate the

cleaning function.

• Touch the Start/Pauze button to start

the programme.

If the appliance is frequently

used, carry out the 

CLE

programme regularly.

ENGLISH

29