In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important!
If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again
depending on the capacity
of water absorption of the
fabrics.
The ProSense detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Save button.
10.9
Interrupting a
programme and changing the
options
When the programme is running, you
can change
only some
options:
1.
Touch the Start/Pause button.
The related indicator flashes.
2.
Change the options. The given
information in the display changes
accordingly.
3.
Touch the button Start/Pause again.
The washing programme continues.
10.10
Cancelling a running
programme
1.
Press the button On/Off to cancel
the programme and to deactivate
the appliance.
2.
Press the button On/Off again to
activate the appliance.
If the ProSense System has
completed and the water
filling has already started,
the new programme starts
without repeating the
ProSense System
. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the
"Reset" position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
10.11
Opening the door -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator
.
1.
Touch the Start/Pause button.
In the display the related door lock
indicator goes off.
2.
Open the appliance door. If
necessary, add or remove the items.
Close the door and touch the Start/
Pause
button.
The programme or the delay start
continues.
10.12
End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
ENGLISH
33