The indicator of the Start/Pauze button
goes off.
The door unlocks and the indicator
goes off.
1.
Press the Aan/Uit button to
deactivate the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last
selected programme. Turn
the programme dial to set a
new cycle.
2.
Remove the laundry from the
appliance.
3.
Make sure that the drum is empty.
4.
Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
5.
Close the water tap.
10.13
Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the
water of the last rinse, the programme is
completed, but:
• The display shows the indicator , the
option indicator
or and the
door locked indicator
. The
indicator of the running phase
flashes.
• The drum still turns at regular intervals
to prevent the creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1.
If necessary, touch the Centrifugeren
button to decrease the spin speed
proposed by the appliance.
2.
Touch the Start/Pauze button:
• If you have set
, the appliance
drains the water and spins.
• If you have set , the appliance
only drains the water.
The option indicator
or goes off,
while the indicator flashes and then
goes off.
3.
When the programme is completed
and the door locked indicator
goes off, you can open the door.
4.
Press the Aan/Uit button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
10.14
Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pauze button.
Press the Aan/Uit button to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the Aan/Uit button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function
doesn't deactivate
the appliance to remind you
to drain the water.
11.
HINTS AND TIPS
WARNING!
Refer to Safety chapters.
11.1
The laundry load
• Divide the laundry into: white,
coloured, synthetics, delicates and
wool.
www.aeg.com
38
