12.4
Ecological hints
To save water, energy and to help protect
the environment, we recommend that
you follow these tips:
•
Normally soiled laundry
may be
washed
without prewash
in order to
save detergent, water and time (the
environment is protected too!).
• Loading the appliance to the
maximum capacity indicated for
each programmes helps to reduce
energy and water consumption
.
• With adequate pre-treatment, stains
and limited soiling can be removed;
the laundry can then be washed at a
lower temperature.
• To use the correct quantity of
detergent, refer to the quantity
suggested by the detergent producer
and check the water hardness of you
domestic system. Refer to 'Water
hardness'.
• Set the
maximum possible spin
speed
for the selected washing
programme
before drying your
laundry in a tumble dryer
. This will
save energy during drying!
12.5
Water hardness
If the water hardness in your area is high
or moderate, we recommend that you
use a water softener for washing
machines. In areas where the water
hardness is soft it is not necessary to use
a water softener.
To find out the water hardness in your
area, contact your local water authority.
Use the correct quantity of water
softener. Follow the instructions that you
find on the packaging of the product.
13.
CARE AND CLEANING
WARNING!
Refer to Safety chapters.
13.1
Periodic cleaning
schedule
Periodic cleaning helps to extend the
life of your appliance.
After each cycle, keep the door and the
detergent dispenser slightly ajar to get
air circulation and dry the humidity inside
the appliance: this will prevent mildew
and odours.
If the appliance is not used for a long
time: close the water tap and unplug the
appliance.
Indicative periodic cleaning schedule:
Descaling
Twice a year
Maintenance wash
Once a month
Clean door seal
Every two months
Clean drum
Every two months
Clean detergent
dispenser
Every two months
Clean drain pump
filter
Twice a year
Clean the inlet hose
and the valve filter
Twice a year
The following paragraphs explain how
you should clean each part.
13.2
Removing foreign objects
Make sure that pockets are
empty and all loose
elements are tied up before
running your cycle. Refer to
'The laundry load' in 'Hints
and tips'.
Remove any foreign objects (such as
metal clip, buttons, coins, etc) that you
may find in the door seal, the filters and
the drum. Refer to 'Door seal with
double lip trap', 'Cleaning the drum',
'Cleaning the drain pump' and 'Cleaning
the inlet hose and the valve filter'
paragraphs. If necessary, please contact
the Authorised Service Centre.
www.aeg.com
30