Main features of your washer-dryer
• Programme and temperature setting using the programme selector.
•
Stain programme
for effectively treating stained washing.
•
Energy saving programme
for normally soiled cotton items.
•
Speed for the final spin
can be reduced to 1000, 900, 700 or 400
rpm.
•
RINSE HOLD
: the laundry is left immersed in the final rinse water to
prevent creasing.
•
Delay timer
: programme start can be delayed by 1 to 19 hours (e.g.
to times with a more economical power rate).
•
Programme progress display
showing the programme steps selected
and the programme phase which is running.
• Because of its gentle washing action, the
special wool cycle
washes
your garments with extreme care.
•
The drying programmes
will enable you to have dry and soft laun-
dry in a short time.
•
3-compartment drawer
for detergent and fabric softener.
•
Unbalance detection device:
to prevent vibration during spinning.
9
Disposal
Packaging materials
The materials marked with the symbol
are recyclable.
>PE<
=polyethylene
>PS<
=polystyrene
>PP<
=polypropylene
This means that they can be recycled by disposing of them properly in
appropriate collection containers.
Machine
Use authorised disposal sites for your old appliance. Help to keep your
country tidy!
Tips for environmental protection
To save water, energy and to help protect the environment, we recommend
that you follow these tips:
• Normally soiled laundry may be washed without prewashing in order
to save detergent, water and time (the environment is protected too!).
• Use the energy saving programme when washing normally soiled garments.
• The machine works more economically if it is fully loaded (for both
washing and drying cycles).
• When small loads are washed, use only half to two thirds of the rec-
ommended amount of detergent.
• The machine will consume less energy if the laundry is
adequately
spun
before being dried.
• With adequate pre-treatment, stains and limited soiling can be
removed; the laundry can then be washed at a lower temperature.
• If the water has a medium or high degree of hardness (starting from
hardness degree II, see “Detergents and additives”) water softeners
must be added.
The amount of detergent can then be adjusted to hardness degree I (= soft).
8
