To clean the water inlet filters:
1.
Close the water tap.
2.
Remove the water inlet hose from the
water tap.
3.
Clean the filter in the inlet hose with a
stiff brush.
4.
Remove the inlet hose behind the
appliance.
5.
Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
6.
Install again the inlet hose. Make sure
that the couplings are tight to pre-
vent leakages.
7.
Open the water tap.
EMERGENCY EMPTYING OUT
If the water is not discharged, proceed as
follows to empty out the appliance:
1.
pull out the plug from the power
socket;
2.
close the water tap;
3.
if necessary, wait until the water has
cooled down;
4.
place a bowl on the floor;
5.
place the end of the emergency emp-
tying hose into the bowl;
6.
Remove its cap. The water should
drain by gravity into the bowl. When
the bowl is full, put the cap back on
the hose. Empty the bowl;
Repeat the procedure until water
stops flowing out;
7.
clean the pump if necessary as previ-
ously described;
8.
replace the emergency emptying
hose in its seat after having plugged
it;
9.
screw the pump again.
FROST PRECAUTIONS
If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1.
close the water tap;
2.
unscrew the water inlet hose from the
tap;
3.
place the end of the emergency emp-
tying hose and that of the inlet hose
in a bowl placed on the floor. Let wa-
ter drain out;
4.
screw the water inlet hose back on;
5.
put the cap on the emergency empty-
ing hose again;
6.
reposition the emergency emptying
hose.
By doing this, any water remaining in the
machine is removed, avoiding ice forming
and consequently damage to the appli-
ance.
When you use the machine again, make
sure that the ambient temperature is
above 0°C.
26 www.aeg.com
Summary of Contents for LAVAMAT 61470 WDBI
Page 39: ...Fig 7 ENGLISH 39 ...
Page 79: ...ESPAÑOL 79 ...
