3.
Set the hose correctly by loosening the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut again to prevent leaks.
4.
Connect the hose to a tap with a 3/4” thread. Always use the hose supplied
with the appliance.
Installation should comply with local water authority and building regulations
requirements. A minimum water pressure of 0.05 MPa is required for safe
operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you
may be able to operate the appliance from your cold water storage system. There
should be a minimum distance of between the appliance’s inlet and the bottom of
the water storage tank.
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose. This fault is shown by a red sector in the
window “
A
”. Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.
Water drainage
This appliance is designed to be permanently plumbed
into your home's drainage system using one of the
following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
43
Installation
P1199
U
piece
supplied
A
352
30 cm (12")
38 mm (1.5)
standpipe
diameter
132969060 gb.qxd 12/09/2007 9.22 Pagina 43