Changing a running programme is possible
only by resetting it
. Turn the programme selec-
tor dial to
and then to the new programme position. Start the new programme by
pressing the
8
button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button
8
to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which is running. Now you can select a
new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button
8
. If the pilot light
10.2
goes off after
some minutes, the door can be opened.
If the door remains locked
-
the pilot light
10.2
is on, this means that the machine is al-
ready heating, that the water level is above the bottom edge of the door. In this case the
door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by
turning the selector dial to . After some minutes the door can be opened
(pay attention
to the water level and temperature !)
.
After closing the door, it is necessary to select the programme and options again and to
press button
8
.
At the end of the programme
The machine stops automatically. The pilot light of button
8
goes off. The pilot lights
10.1
and
10.2
go off. A blinking will appear on the display.
If a programme or an option that ends with water still in the tub has been set, the pilot
light
10.2
illuminates. A blinking will appear on the display. The pilot light of button
8
goes off. The door remains locked. The water must be emptied out. During this time the
drum continues to turn at regular intervals until water drain.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the DRAIN or SPIN programme
• If necessary, press the relevant button to reduce the spin speed,
• Press button
8
.
• When the programme has finished the display shows a blinking . The pilot light
10.2
goes off. The door can be opened.
Turn the programme selector dial to to switch the machine off. Remove the laundry
from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand by
: once the programme has finished after a few minutes the energy saving system
will be enabled. The brightness of the display is reduced. By pressing any button the appli-
ance will come out of the energy saving status.
15
