Opening the door after the programme has started
First set the machine to pause by pressing the button
7
.
• If the DOOR symbol disappears, the door can be opened;
• If the DOOR symbol doesn’t go off, it means that the machine is already heating, that
the water level is above the bottom edge of the door. In this case the door cannot be
opened;
• If you cannot open the door but you need to open it, you have to switch the machine
off by turning the selector dial to
. After some minutes the door can be opened
(pay
attention to the water level and temperature!)
;
After closing the door, it is necessary to select the programme again and to press button
7
.
At the end of the programme
The machine stops automatically, the pilot light of button
7
pilot light goes off, a blinking
appears on the display and the acoustic signal sounds for some minutes.
If you have chosen a programme or an option that ends with water in the tub,
follow the
below instruction to empty the water out:
• turn the programme selector dial to
• select the DRAINING or SPINNING programme
• reduce the spin speed if needed, by means of the relevant button
• press the button
7
• when the programme has finished the display shows a blinking . On the display the
DOOR symbol disappears and the door can be opened.
Turn the programme selector dial to
to switch the machine off. Remove the laundry
from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open
to prevent the formation of mildew and unpleasant smells.
Stand by
: once the programme has finished after a few minutes the energy saving system
will be enabled. The brightness of the display is reduced. By pressing any button the ap-
pliance will come out of the energy saving status.
14
