Downloaded from www.vandenborre.be
Starting the programme
Press the START PAUSE (START PAUZE) button.
Changing programme
To change a running programme:
1. Turn the programme selector to OFF (UIT) position.
2. Select new programme.
3. Press START PAUSE (START PAUZE) button.
Cycle end / laundry unloading
If the drying cycle is complete the phase lamp END (EINDE) is on and acoustic signal sounds
intermittently one minute (only when BUZZER (ZOEMER) function is active).
The drying cycle is automatically followed by an anti-crease phase which lasts around 30
minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and
free of creases. The laundry can be removed at any time during the anti-crease phase. (The
laundry should be taken out towards the end of the anti-crease phase at the latest to
prevent creases from forming.)
1. Open the loading door.
2. Remove the fluff from fluff filters. (See “
Care and cleaning
” chapter.)
3. Unload the laundry.
4. Turn off the dryer - programme selector on OFF (UIT) position.
5. Close the loading door.
After each drying cycle:
– clean the fluff filters
– empty water reservoir
Care and cleaning
Cleaning fluff filter
The filters collect all the fluff which accumulates during drying. To ensure that the dryer
works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after
every drying cycle.
The warning led is on to remind you this operation.
CAUTION!
Never operate the dryer without fluff filters or with damaged or blocked fluff filters.
76
Care and cleaning
