13.1 NON-STOP programme -
Washing and drying mode
Not all programmes are
compatible with drying
mode.
In some washing programmes, you can
combine WASH and DRY mode for
running a complete wash&dry
programme. Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the DRY mode button once to
activate also the drying function. The
leds of the WASH and DRY
indicators come on. The indicators
and
appear in the
display. The display also shows the
maximum recommended load for a
washing and drying programme (e.g.
5.0 kg for cottons).
When drying a large laundry
load, make sure that the
garments are not rolled up
and that are uniformly
distributed in the drum.
13.2 Washing and Drying -
Automatic levels
The default level is the cupboard dry
one. In some programmes
you can change the drying level.
1. Tap on the Auto Dry button
repeatedly until the display shows the
required dryness level. The indicators
in the display illuminate accordingly:
a.
Iron dry: for cotton
items;
b.
Cupboard dry: for
cotton and synthetic items;
c.
Extra dry: for cotton
items.
The time value on the display is the
duration of both cycles washing and
drying.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch the Start / Pause
button to
start the programme. The ProSense
estimation starts.
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
13.3 Washing and Timed
Drying
You can also exclude the automatic
drying mode, and choose a drying time
manually:
1. Tap on the Time Dry button
repeatedly to set the desired time
value (see the "Timed drying" table in
the "Programmes" chapter). The
Auto Dry l indicator goes off and the
indicator comes on.
The minimum timed drying is 10 minutes.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start / Pause
button to
start the programme. The ProSense
estimation starts.
In the display the door locked
indicator comes on and the indicator of
the running phase starts flashing.
The display also shows the remaining
programme time.
www.aeg.com
40
