E
N
G
L
IS
H
E
N
G
L
IS
H
ENGLISH
45
Start-up of the device/Introduction
• Read the operating instructions thoroughly before the start-
up!
• Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
• Make sure that the device is adequately ventilated!
• Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker R and L“ (23).
• Insert the plug into a properly installed 230 V, 50 Hz power
socket. The STANDBY (2) control lamp shows the function.
Please ensure that the mains voltage corresponds to the
information on the type plate.
Note:
The lithium cell in the battery compartment of the remote
control has been secured for transport with a foil. This prolongs
the lifetime of the battery. Before initial use please remove this
foil so that the remote control is ready for operation.
Setting the Time (in Standby Mode)
1. Press the PROG/CLK-ADJ button (21/8) twice. The words
„12/24H:“ appear in the display.
2. Use
the
I
/
I
SEARCH/SKIP buttons (15/16/5) to
choose between the 24 hour and 12 hour display. Press the
PROG/CLK-ADJ button (21/8) to confi rm.
NOTE:
The following appears in the case of the 12 hour display
AM = in the morning, PM = in the afternoon/evening.
3. Press
the
I
/
I
SEARCH/SKIP buttons (15/16/5)
to set the hours. Keep the button pressed down until the
desired hour is reached. Press the PROG/CLK-ADJ button
(21/8) to confi rm.
4. Press
the
I
/
I
SEARCH/SKIP (15/16/5) button in
order to set the minutes. Keep the button pressed down until
the desired minutes are reached.
5. Press the PROG/CLK-ADJ button (21/8) again to store the
time.
NOTE:
If the device is disconnected from the mains the time has to be
set again afterwards.
Inserting the Batteries
The battery of the remote control is a long-life lithium cell. If
the range of the remote control is reduced during use, please
proceed as follows:
• Open the battery compartment on the back of the remote
control.
• Replace the cell by a battery of the same type. Ensure
correct polarity.
• Then close the battery lid.
If the remote control is not used for a prolonged period, remove
the batteries in order to prevent battery acid leaking.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer’s.
Never throw batteries into the fi re.
CD deck transport protection
• Please open the CD compartment (11) by pressing the
OPEN/CLOSE button (12).
• Remove the transport protection from the CD player if
present before use.
General Operation
ON/STANDBY (1)
Switch the music centre to standby using the ON/STANDBY
button (the STANDBY control lamp lights up in red). When this
button is pressed again the STANDBY control lamp goes off and
the device switches on again.
X-BASS (4)
This is used to amplify the bass sounds. Press the button in
order to turn this function on and off.
BASS ON, BASS OFF.
Volume
You can set the desired volume using the Λ / V / - / + VOLUME
control (5) (2 on the remote control).
FUNCTION (19/10)
In conjunction with the function selector switch (6) this button is
used to select between CD, USB and SD/MMC.
Infrared remote control
For operating the music centre from a distance of up to 5 metres
without a lead. If the range of the remote control is reduced, the
batteries have to be replaced. During operation ensure that there
is nothing blocking the direct line between the remote control
and the sensor (3) on the machine.
LINE IN socket (18)
To connect analogue replay devices. Use this jack to replay
sound of other replay equipment such as DVD players, compu-
ters, etc. via the loudspeakers.
1. Open the
OPEN
(20) fl ap.
2. Please connect the external device with a 3.5 mm stereo
jack plug to the LINE IN socket.
3. Turn the function selector switch (6) to the AUX position.
4. Through the loudspeakers you will hear the sound played
back from the external device; you can change the volume
with the
n
/
!
/– /+ VOLUME buttons (5) (2 on the remote
control). The CD buttons have no function in this mode.
5. For the remaining procedure please see the operating
instructions of the external sound source.
05-MC 4406 AEG New4 45
31.10.2006, 14:39:53 Uhr
