English
28
You can use the button to skip a title and to change to the
next title. To do this, please proceed as follows:
• Press the button briefly.
• By pressing down and holding the button, the music
search is activated. The title is not changed but is wound
forward in fast forward mode.
With the button you wil proceed as follows:
• Pressing it 1x drücken will change it to the start of the
current title.
• By pressing it 2x, it will change to the previous title.
• Pressing it 1x and holding it down will activate the music
search run backwards.
REP/RAN (20/29) button
This button enables you to set different options of music
replay. To do this, procced as follows:
• Pressing 1x will repeat the current title until the function is
deactivated.
• Pressing 2 x will replay the entire CD until the function is
deactivated.
• Pressing 3 x will activate the random replay of the music
titles.
If the button is pressed again, the function is deactivated
again. The replay will run in the normal mode.
When replaying an MP3-CD you may select the folder in one
of the upper settings with the FOLDER (17/27) button during
the replay, for which the settings shall be adopted.
Programmed playback
Allows the programming of any desired order of selections.
To program the order of selections, please proceed as
follows:
• Insert a music medium (Audio – CD / MP3 - CD/ USB
stick)
• Press the PROG button (21/23). “P01” will appear in the
display. The “Memory” notification will also appear.
• Now select the desired title on the remote control with
the / (26/31) buttons.
• Press the PROG (21/23) button again. “P02” will appear
in the display.
• Select another title.
• Proceed the same way with the further programming.
• You will start the playback with the
button (16/25).
To erase the programming, press the button (22/30) twice.
The “Memory” notification will go out.
Bluetooth Streaming/AUX
To playback music through the Bluetooth or AUX, please
proceed as follows:
• Slide the operating mode switch (10) to the Bluetooth/
AUX position.
• Pair your music output device with Bluetooth with the
device. The Bluetooth password of the device is “0000”.
You may alternately connect the music output source by
using a 3.5 mm jstereo jack plug with the AUX terminal (11)
of the device.
• Select the desired music titles.
• Start the playback.
NOTE:
Before you start the replay, ensure a moderate output
volume of the music source and of the device. Adjust
the volume later on.
Troubleshooting
Symptoms
Cause
Solution
CD can not be
played back.
CD has not been
inserted correctly.
Ensure that the CD
has been inserted
correctly.
CD skips during
the playback.
CD is dirty.
Clean the CD with a
soft, dry towel.
No audio signal
during Bluetooth
playback.
Device not paired
correctly.
Perform the pairing
one more time.
Device out of
range.
Reduce the range.
No playback of
music.
No error
noticeable.
Contact Customer
Service.
No playback
from the USB
stick.
USB stick not
compatible.
Replace the USB
stick with a different
one.
Bad radio
reception.
Unfavorable
reception position.
Change the direction
of the antenna or
reposition the device.
Switch to MONO
operation
Cleaning and maintenance
To clean the device, please proceed as follows:
• Separate the device from the mains.
• Wipe the outer surfaces of the device with a dry towel
without any cleaning additives.
