AEG NSC7G751ES, User Manual

Overall space required in use ³

H3 (A+B)

mm

1923

W3

mm

696

D3

mm

1229

³ the height, width and depth of the

appliance including the handle, plus the

space necessary for free circulation of

the cooling air, plus the space necessary

to allow door opening to the minimum

angle permitting removal of all internal

equipment

3.2 Location

To ensure appliance's best functionality,

you should not install the appliance in the

nearby of the heat source (oven, stoves,

radiators, cookers or hobs) or in a place

with direct sunlight. Make sure that air

can circulate freely around the back of

the cabinet.
This appliance should be installed in a

dry, well ventilated indoor position.
This appliance is intended to be used at

ambient temperature ranging from 10°C

to 43°C.

The correct operation of the

appliance can only be

guaranteed within the

specified temperature range.

If you have any doubts

regarding where to install the

appliance, please turn to the

vendor, to our customer

service or to the nearest

Authorised Service Centre.

It must be possible to

disconnect the appliance

from the mains power

supply. The plug must

therefore be easily

accessible after installation.

3.3 Electrical Connection

CAUTION!

Any electrical work required

to install this appliance

should be carried out by a

qualified electrician or

competent person.

WARNING!

This appliance must be

earthed.

The manufacturer declines

any liability should these

safety measures not be

observed.

The wires in the mains lead are coloured

in accordance with the following code:

A

B

C

D

E

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains

lead of this appliance may not

correspond with the coloured markings

identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and

yellow to the terminal marked either

with the letter “E“ or by the earth
symbol   or coloured green and

yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter

“N“ or coloured black.

3. Connect the wire coloured brown to

the terminal either marked with the

“L“ or coloured red.

www.aeg.com

8