Troubleshooting
34
Washing has not been
spun sufficiently, there
is water left in the
drum.
Error code
(2
appears.
There is a kink in the outlet
hose.
Eliminate the kink.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Please contact AEG Service
Force Centre, it has a retro-
kit available for pump
heights above 1m.
Drain pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
The water drainage system is
blocked.
Clean the blockage.
The door cannot be
opened with the
machine on.
The door is locked due to
safety reasons (DOOR display
is off).
Wait until the DOOR display
is green.
The rinse water is
cloudy.
Probably caused by a
washing powder with a high
silicate content.
This does not affect the
rinse results. If necessary use
liquid detergent.
When pressing a
program option button
the corresponding
display does not light
up.
The program option selected
is not available with the
program set.
Make another selection.
Washing powder
residues are left in the
washing powder
compartment.
The water tap is not fully
open.
Open the water tap fully.
The inlet hose filter is
blocked.
Clean the filter.
The inlet valve filter is
blocked.
Disconnect the inlet hose
from the machine and clean
filter.
Fault
Possible cause
Remedy