The core temperature sensor
must stay in the meat and in
the socket during the
cooking.
1.
Activate the appliance.
2.
Put the point of the core temperature
sensor (with on the handle) into
the centre of the meat.
3.
Put the plug of the core temperature
sensor into the socket at the front of
the appliance.
The display shows flashing and the
default set core temperature. The
temperature is 60 °C for the first
operation, and the last set value for each
subsequent operation.
When you put the core
temperature sensor into the
socket, you cancel the
settings for the clock
functions.
4.
Touch
or
to set the core
temperature.
5.
Touch
or the settings save
automatically after 5 seconds.
You can set the core
temperature only when
flashes. If is in the
display but does not
flash before you set the
core temperature, touch
and
or
to set
a new value.
6.
Set the oven function and the oven
temperature.
The display shows the current core
temperature and the heat up symbol .
While the appliance calculates the
approximate duration time, the display
shows the count up time. After the first
calculation the display shows the
approximate duration of the cooking
time.
The appliance continues to calculate the
duration during the cooking. The display
updates at intervals with the new
duration value.
When you cook with the
core temperature sensor,
you can change the
temperature shown in the
display. After you put the
core temperature sensor in
the socket and set an oven
function and temperature,
the display shows the
current core temperature.
Touch again and again to
see three other
temperatures:
• the set core
temperature
• the current oven
temperature
• the current core
temperature.
When the meat is at the set core
temperature, an acoustic signal sounds
for two minutes and the value of the core
temperature and flash. The appliance
deactivates.
7.
Touch a sensor field to deactivate
the acoustic signal.
8.
Remove the core temperature sensor
from the socket and remove the
meat from the appliance.
WARNING!
Be careful when you remove
the core temperature
sensor. It is hot. There is a
risk of burns.
9.2
Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
www.aeg.com
18
