23
EN
x
Protect units against external influences (particularly humidity
and dust). In this regard, observe the information in chapter
3
as from page 16 of these operating instructions.
x
If the device is brought from a cold room to a warm room, or
if the room temperature drops suddenly, condensation may
occur inside the device. Let the device sit for 2 hours before
turning it on to avoid the formation of condensation.
x
Ensure that no magnetic storage media are stored and/or
used near the Protect B.
PRO.
Check on the rating plate whether the voltage and
frequency
specifications
match
the
values
applicable for your electrical loads.
4.3
Installation
4.3.1 Installation in a 19" rack
Install the drawers from your network cabinet manufacturer or
the optional UPS rack rails from the AEG product line, preferably
in the lower third of the cabinet. Take the cabinet's centre of
gravity and sufficient fresh air supply into consideration here.
Before inserting the device or the external battery unit into the
network cabinet, attach the side mounting brackets included with
the delivery beforehand.
Step 1:
Step 2:
