32
used and should not be displayed
as a control option.
Battery Test
Schedule Battery Test: yes Cancel
Battery test: no
Starts a manual battery test.
Reset Error State
Reset Alarms: yes | no
Manually clears any latched
alarms, such as bad battery
detected or DC Bus over voltage/
under voltage.
If a bad battery alarm was also
active, reset the battery test
status to “Not Tested”.
Load Segments
Load segment 1: on | off Load
segment 2: on | off
These on/off commands override
automatic load segment on/off
controls made by the Automatic
Start Delay and Automatic On
Battery Shutdown settings.
6.2.4
Configuring Load Segments
Load segments are sets of receptacles that can be controlled by power
management software or through the display, providing an orderly
shutdown and startup of your equipment. For example, during a power
outage, you can keep key pieces of equipment running while you turn off
other equipment. This feature allows you to save battery power and to get
a controlled shutdown and later by using the time-delayed switching-on a
controllable reboot of the network devices.
Load segment 0: The highest-level outlets (directly fed by UPS
output – not manageable)
Load Segment 1 and 2: Outlets for loads, which should be
controlled during operation, that means which should be
manageable.
