AEG RCB53725MW, User Manual

Problem

Possible cause

Solution

The FROSTMATIC function
is switched on.

Refer to "FROSTMATIC func-
tion".

The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.

This is normal, no error has
occurred.

The compressor starts after
some time.

Water flows inside the re-
frigerator.

The water outlet is clog-
ged.

Clean the water outlet.

Food products prevent wa-
ter from flowing into the
water collector.

Make sure that food products
do not touch the rear plate.

Water flows on the floor.

The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.

Attach the melting water out-
let to the evaporative tray.

Temperature cannot be set. The FROSTMATIC or

COOLMATIC function is
switched on.

Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".

The temperature in the ap-
pliance is too low/too high.

The temperature regulator
is not set correctly.

Set a higher/lower tempera-
ture.

The food products temper-
ature is too high.

Let the food products temper-
ature decrease to room tem-
perature before storage.

Many food products were
stored at the same time.

Store less food products at the
same time.

The FROSTMATIC function
is switched on.

Refer to "FROSTMATIC func-
tion".

Side panels of the appli-
ance are warm.

This is a normal state
caused by operation of the
heat exchanger.

Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when
the ambient temperature ex-
ceeds 38°C.

There is too much con-
densed water on the rear
wall of the refrigerator.

Door was opened too fre-
quently.

Open the door only when nec-
essary.

www.aeg.com

10