A
B
100 mm min
20 mm
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible af-
ter installation.
8.3
Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
8.4
Rear spacers
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.
Release the screw.
2.
Engage the spacer below the screw.
3.
Turn the spacer to the right position.
4.
Tighten again the screws.
2
4
3
1
8.5
Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
8.6
Removing the shelf
holders
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1.
Move the shelf holders in the direc-
tion of the arrow (A).
2.
Raise the shelf from the rear and
push it forward until it is freed (B).
3.
Remove the retainers (C).
30 www.aeg.com
