• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.
8.4
Removing the transport
support
Your appliance is equipped with
transport support to secure the door
during transportation.
1.
Open the door.
2.
Remove the transport support from
the door sides.
3.
Remove the transport support from
the lower hinge (some models).
CAUTION!
Some models are fitted with
a silencing pad under the
cabinet. Do not remove this
pad.
2
3
8.5
Rear spacers
Install the two spacers and the locking
pins provided within the accessory bag
as shown in the figure.
8.6
Levelling
When placing the appliance ensure that
it stands level. If necessary adjust the feet
using the adjustment spanner supplied.
Door alignment is dependent on proper
levelling.
8.7
Door reversibility
WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
1.
Remove the ventilation grille.
Remove the upper filling and install it
on the opposite side of the grille.
2.
Lay down the appliance back side
down on a wooden support.
3.
Unscrew the handle from the bottom
and the top of the door (1, 3) and the
screw on top of the handle (2).
www.aeg.com
34
Summary of Contents for S73130KDX3
Page 20: ...buurt of neem contact op met de gemeente www aeg com 20 ...
Page 77: ...DEUTSCH 77 ...
Page 78: ...www aeg com 78 ...
Page 79: ...DEUTSCH 79 ...