AEG SCB618F3LF, User Manual

Problem

Possible cause

Solution

Food products placed in the

appliance were too warm.

Allow food products to cool

to room temperature before

storing.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The Frostmatic function is

switched on.

Refer to "Frostmatic func‐

tion" section.

The compressor does not

start immediately after

pressing the "Frostmatic", or

after changing the tempera‐

ture.

The compressor starts after

a period of time.

This is normal, no error has

occurred.

Door is misaligned or inter‐

feres with ventilation grill.

The appliance is not level‐

led.

Refer to installation instruc‐

tions.

Door does not open easily.

You attempted to re-open

the door immediately after

closing.

Wait a few seconds between

closing and re-opening of

the door.

The lamp does not work.

The lamp is in stand-by

mode.

Close and open the door.

The lamp is defective.

Contact the nearest Author‐

ized Service Centre.

There is too much frost and

ice.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The gasket is deformed or

dirty.

Refer to "Closing the door"

section.

Food products are not wrap‐

ped properly.

Wrap the food products bet‐

ter.

Temperature is set incorrect‐

ly.

Refer to "Control Panel"

chapter.

Appliance is fully loaded and

is set to the lowest tempera‐

ture.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Temperature set in the appli‐

ance is too low and the am‐

bient temperature is too

high.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Water flows on the rear plate

of the refrigerator.

During the automatic de‐

frosting process, frost melts

on the rear plate.

This is correct.

www.aeg.com

16