AEG SCE818E6NS, User Manual

Problem

Possible cause

Solution

Door is misaligned or inter-
feres with ventilation grill.

The appliance is not level-
led.

Refer to installation instruc-
tions.

Door does not open easily.

You attempted to re-open
the door immediately after
closing.

Wait a few seconds between
closing and re-opening of
the door.

The lamp does not work.

The lamp is in stand-by
mode.

Close and open the door.

The lamp is defective.

Contact the nearest Author-
ized Service Centre.

There is too much frost and
ice.

The door is not closed cor-
rectly.

Refer to "Closing the door"
section.

The gasket is deformed or
dirty.

Refer to "Closing the door"
section.

Food products are not wrap-
ped properly.

Wrap the food products bet-
ter.

Temperature is set incorrect-
ly.

Refer to "Control Panel"
chapter.

Appliance is fully loaded and
is set to the lowest tempera-
ture.

Set a higher temperature.
Refer to "Control Panel"
chapter.

Temperature set in the appli-
ance is too low and the am-
bient temperature is too
high.

Set a higher temperature.
Refer to "Control Panel"
chapter.

Water flows on the rear plate
of the refrigerator.

During the automatic de-
frosting process, frost melts
on the rear plate.

This is correct.

There is too much con-
densed water on the rear
wall of the refrigerator.

Door was opened too fre-
quently.

Open the door only when
necessary.

Door was not closed com-
pletely.

Make sure the door is closed
completely.

Stored food was not wrap-
ped.

Wrap food in suitable pack-
aging before storing it in the
appliance.

Water flows inside the refrig-
erator.

Food products prevent the
water from flowing into the
water collector.

Make sure that food prod-
ucts do not touch the rear
plate.

The water outlet is clogged. Clean the water outlet.

ENGLISH

19