Problem
Possible cause
Solution
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set.
The "Frostmatic function" or
"Coolmatic function" is
switched on.
Switch off "Frostmatic func-
tion" or "Coolmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frostmat-
ic function" or "Coolmatic
function" section.
The temperature in the ap-
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door"
section.
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are stor-
ed at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if neces-
sary.
The Frostmatic function is
switched on.
Refer to "Frostmatic func-
tion" section.
The Coolmatic function is
switched on.
Refer to "Coolmatic func-
tion" section.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance. Refer to "Hints and
Tips" chapter.
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK key pressed for
approximately 10 seconds
until a long sound is heard
and the display turns off for
a short time.
A
or
or
symbol is
shown instead of numbers
on the temperature display.
Temperature sensor prob-
lem.
Contact the nearest Author-
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
www.aeg.com
20
Summary of Contents for SCE818E6NS
Page 1: ...USER MANUAL EN User Manual Fridge Freezer SCE818E6NS ...
Page 23: ......