AEG SCE818F6NS, User Manual

Problem

Possible cause

Solution

Water flows on the floor.

The melting water outlet is

not connected to the evapo‐

rative tray above the com‐

pressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be set. The "Frostmatic function" or

"Coolmatic function" is

switched on.

Switch off "Frostmatic func‐

tion" or "Coolmatic function"

manually, or wait until the

function deactivates auto‐

matically to set the tempera‐

ture. Refer to "Frostmatic

function" or "Coolmatic func‐

tion" section.

The temperature in the appli‐

ance is too low/too high.

The temperature is not set

correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The food products' tempera‐

ture is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are stor‐

ed at the same time.

Store less food products at

the same time.

The door has been opened

often.

Open the door only if neces‐

sary.

The Frostmatic function is

switched on.

Refer to "Frostmatic func‐

tion" section.

The Coolmatic function is

switched on.

Refer to "Coolmatic function"

section.

There is no cold air circula‐

tion in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance. Refer to "Hints and

Tips" chapter.

DEMO appears on the dis‐

play.

The appliance is in demon‐

stration mode.

Keep the OK key pressed for

approximately 10 seconds

until a long sound is heard

and the display turns off for

a short time.

A   or   or   symbol is

shown instead of numbers

on the temperature display.

Temperature sensor prob‐

lem.

Contact the nearest Author‐

ized Service Centre (the

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible).

www.aeg.com

20