Problem
Possible cause
Solution
Water flows inside the refrig-
erator.
Food products prevent the
water to flow into the wa-
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged.
Clean the water outlet.
Water flows on the floor.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
Switch off "FROSTMATIC
function" or "COOLMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tem-
perature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time.
Add less food products at the
same time.
The door has been
opened often.
Open the door only if necessa-
ry.
The "FROSTMATIC func-
tion" or "COOLMATIC
function" is switched on.
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold air
circulation in the appliance.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
8.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
8.3
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
assembly instructions.
www.aeg.com
32
Summary of Contents for SCE81911TS
Page 71: ...DEUTSCH 71 ...