AEG SCS6181LNS, User Manual

Problem

Possible cause

Solution

The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.

This is normal, no error has
occurred.

The compressor starts after a
period of time.

Water flows on the rear
plate of the refrigerator.

During the automatic de-
frosting process, frost
melts on the rear plate.

This is correct.

Water flows inside the refrig-
erator.

The water outlet is clog-
ged.

Clean the water outlet.

Food products prevent
that water flows into the
water collector.

Make sure that food products
do not touch the rear plate.

Temperature cannot be set.

The FROSTMATIC or
COOLMATIC function is
switched on.

Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".

The temperature in the ap-
pliance is too low/too high.

The temperature regulator
is not set correctly.

Set a higher/lower tempera-
ture.

The door is not closed cor-
rectly.

Refer to "Closing the door".

The food products' tem-
perature is too high.

Let the food products temper-
ature decrease to room tem-
perature before storage.

Many food products are
stored at the same time.

Store less food products at the
same time.

The door has been
opened often.

Open the door only if necessa-
ry.

There is no cold air circula-
tion in the appliance.

Make sure that there is cold air
circulation in the appliance.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

7.2 

Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

7.3 

Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer to

assembly instructions.

3.

If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

www.aeg.com

12