Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
9.5
Installing the appliance
CAUTION!
Make sure that the mains
cable can move freely.
1.
If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
x
x
2.
Install the appliance in the niche.
3.
Push the appliance in the direction of
the arrows (1) until the upper gap
cover stops against the kitchen
furniture.
1
2
4.
Push the appliance in the direction of
the arrows (2) against the cupboard
on the opposite side of the hinge.
5.
Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in the
accessories bag) makes sure that the
distance between the appliance and
the kitchen furniture is correct.
Make sure that the clearance
between the appliance and the
cupboard is 4 mm.
6.
Open the door. Put the lower hinge
cover in position.
4 mm
44 mm
7.
Attach the appliance to the niche
with 4 screws.
www.aeg.com
32
Summary of Contents for SDS51200S1
Page 75: ...DEUTSCH 75 ...
