--
-
..
,
..
,,,",,,
Unscrew the tht~e bolts of the support on the mounting plate.
The three nuts at the rear of this plate are crimped on.
-
Unscrew the fOl.I
r bolts securi ng the motor to its support.
Pullout
the pir securing the p{ni~n on the motor shaft (pin dia.
3
mm).
Replace the motlr and proceed vice versa.
Unscrew the support from the wiring plate.
Rep
1
ace the hea,1:erand proceed vice versa.
Remove the two :iecuring rings and then pu
11
out the small ax
1
e
from the switch eyelet.
Press the lever into upright position.
Remove the two ruts securing the switch to its support.
-
After·replacing
the switch, tighten the two nuts on the support.
Reset the axle and the two bushes in the eyelet and fit the two
securing rings.
Summary of Contents for SF6
