AEG SFB688F1AS, User Manual

Problem

Possible cause

Solution

Appliance is fully loaded and

is set to the lowest tempera‐

ture.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Temperature set in the appli‐

ance is too low and the am‐

bient temperature is too

high.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Water flows on the rear plate

of the refrigerator.

During the automatic de‐

frosting process, frost melts

on the rear plate.

This is correct.

There is too much con‐

densed water on the rear

wall of the refrigerator.

Door was opened too fre‐

quently.

Open the door only when

necessary.

Door was not closed com‐

pletely.

Make sure the door is closed

completely.

Stored food was not wrap‐

ped.

Wrap food in suitable pack‐

aging before storing it in the

appliance.

Water flows inside the refrig‐

erator.

Food products prevent the

water from flowing into the

water collector.

Make sure that food prod‐

ucts do not touch the rear

plate.

The water outlet is clogged.

Clean the water outlet.

Water flows on the floor.

The melting water outlet is

not connected to the evapo‐

rative tray above the com‐

pressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be set. The "Frostmatic function" is

switched on.

Switch off "Frostmatic func‐

tion" manually, or wait until

the function deactivates au‐

tomatically to set the temper‐

ature. Refer to "Frostmatic

function" section.

The temperature in the appli‐

ance is too low/too high.

The temperature is not set

correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The food products' tempera‐

ture is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are stor‐

ed at the same time.

Store less food products at

the same time.

ENGLISH

17