54
Check and clean the outlet
of melting water coming
during defrosting regularly.
If it is clogged the melting water
gathered can cause earlier failure
as it can go to the insulating of
the appliance.
Clean the melting water outlet
with the supplied pipe scraper that
can be seen in the figure. The pipe
scraper has to be stored in the
outlet.
Occasionally check defrost water outlet not to be clogged up.
The most typical case of clogging up in the defrost water outlet when you
put food wrapped in some paper into the appliance and this paper contacts
back plate of fresh food compartment and freezes to it. If you remove the
food right at this moment the paper will tear and it can cause clogging up
in the outlet by getting into it. So you are asked to be careful - because of
the above - when placing foods wrapped in paper into the appliance.
In case of increased demand e.g. during heatwaves, the refrigerator
temporarily happens to operate constantly. During this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of the fresh food
compartment after defrosting period is not abnormal.
The frozen food compartment can not be equipped with automatic
defrosting set since the deep-frozen and frozen foods do not endure melting
temperature.
Provided it is not too thick, the layer of frost or ice can be scraped off and
removed using a plastic scraper.
When ice coating is so thick that it can not be removed with the plastic
scraper, the frozen food compartment has to be defrosted (generally 2-3
times a year).
Take the foods out of the frozen and fresh food compartment, wrap them
into some layers of paper or cloth. Put them to a possible cool place while
defrosting.
Break the circuit of the appliance and leave the doors of frozen and fresh
food compartment open.
Continuously blot off the defrosting water by a soft cloth or sponge.
After defrosting wipe the surfaces, apply voltage to the appliance and put the
foods back to their places.
