Problem
Possible cause
Solution
Door is misaligned or inter-
feres with ventilation grill.
The appliance is not level-
led.
Refer to installation instruc-
tions.
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of
the door.
The lamp does not work.
The lamp is in stand-by
mode.
Close and open the door.
The lamp is defective.
Refer to "Replacing the
lamp" section.
There is too much frost and
ice.
The door is not closed cor-
rectly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
Temperature is set incorrect-
ly.
Refer to "Control Panel"
chapter.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic de-
frosting process, frost melts
on the rear plate.
This is correct.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was opened too fre-
quently.
Open the door only when
necessary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrap-
ped.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Water flows inside the refrig-
erator.
Food products prevent the
water from flowing into the
water collector.
Make sure that food prod-
ucts do not touch the rear
plate.
The water outlet is clogged. Clean the water outlet.
ENGLISH
13
Summary of Contents for SKE588F1AS
Page 1: ...USER MANUAL EN User Manual Refrigerator SKE588F1AS ...
Page 17: ...ENGLISH 17 ...
Page 18: ...www aeg com 18 ...
Page 19: ...ENGLISH 19 ...