Problem
Possible cause
Solution
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in the ap-
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door"
section.
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if neces-
sary.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance. Refer to "Hints and
Tips" chapter.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
8.2
Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from
the mains socket.
1.
Pull the left side of the lamp cover
with your fingers to unlock it. Remove
the cover by pulling it towards
yourself.
1
2
1
2.
Replace the bulb with one of the
same power and shape, specifically
designed for household appliances.
3.
Install the lamp cover.
4.
Connect the plug to the mains
socket.
5.
Open the door.
Make sure that the light switches on.
8.3
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
installation instructions.
www.aeg.com
14
Summary of Contents for SKE588F1AS
Page 1: ...USER MANUAL EN User Manual Refrigerator SKE588F1AS ...
Page 17: ...ENGLISH 17 ...
Page 18: ...www aeg com 18 ...
Page 19: ...ENGLISH 19 ...