AEG SKK81821DC, User Manual

•

Do not store explosive substances such as aerosol

cans with a flammable propellant in this appliance.

•

If the supply cord is damaged, it must be replaced by

the manufacturer, its Authorised Service Centre or

similarly qualified persons in order to avoid a hazard.

2. 

SAFETY INSTRUCTIONS

2.1 

Installation

WARNING!

Only a qualified person must

install this appliance.

• Remove all the packaging and the

transit bolts.

• Do not install or use a damaged

appliance.

• Follow the installation instruction

supplied with the appliance.

• Always take care when moving the

appliance as it is heavy. Always use

safety gloves and enclosed footwear.

• Make sure the air can circulate around

the appliance.

• At first installation or after reversing

the door wait at least 4 hours before

connecting the appliance to the

power supply. This is to allow the oil

to flow back in the compressor.

• Before carrying out any operations on

the appliance (e.g. reversing the

door), remove the plug from the

power socket.

• Do not install the appliance close to

radiators or cookers, ovens or hobs.

• Do not install the appliance where

there is direct sunlight.

• Do not install this appliance in areas

that are too humid or too cold, such

as the construction appendices,

garages or wine cellars.

• When you move the appliance, lift it

by the front edge to avoid scratching

the floor.

• The appliance contains a bag of

desiccant. This is not a toy. This is not

food. Please dispose of it

immediately.

2.2 

Electrical connection

WARNING!

Risk of fire and electrical

shock.

• The appliance must be earthed.

• Make sure that the parameters on the

rating plate are compatible with the

electrical ratings of the mains power

supply.

• Always use a correctly installed

shockproof socket.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to

the electrical components (e.g. mains

plug, mains cable, compressor).

Contact the Authorised Service

Centre or an electrician to change the

electrical components.

• The mains cable must stay below the

level of the mains plug.

• Connect the mains plug to the mains

socket only at the end of the

installation. Make sure that there is

access to the mains plug after the

installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

2.3 

Use

WARNING!

Risk of injury, burns,

electrical shock or fire.

• Do not change the specification of

this appliance.

• Do not put electrical appliances (e.g.

ice cream makers) in the appliance

unless they are stated applicable by

the manufacturer.

• Be careful not to cause damage to

the refrigerant circuit. It contains

www.aeg.com

4