AEG SKS91000F0, User Manual

WARNING!

Any electrical component (power
cord, plug, compressor) must be
replaced by a certified service
agent or qualified service per-
sonnel to avoid hazard.

1.

Power cord must not be length-
ened.

2.

Make sure that the power plug is
not squashed or damaged by the
back of the appliance. A squashed
or damaged power plug may
overheat and cause a fire.

3.

Make sure that you can come to
the mains plug of the appliance.

4.

Do not pull the mains cable.

5.

If the power plug socket is loose,
do not insert the power plug.
There is a risk of electric shock or
fire.

6.

You must not operate the appli-
ance without the lamp cover (if
foreseen) of interior lighting.

• This appliance is heavy. Care should

be taken when moving it.

• Do not remove nor touch items from

the freezer compartment if your hands
are damp/wet, as this could cause skin
abrasions or frost/freezer burns.

• Avoid prolonged exposure of the ap-

pliance to direct sunlight.

• Bulb lamps (if foreseen) used in this

appliance are special purpose lamps
selected for household appliances use
only. They are not suitable for house-
hold room illumination.

1.3 

Daily use

• Do not put hot pot on the plastic parts

in the appliance.

• Do not store flammable gas and liquid

in the appliance, because they may
explode.

• Appliance's manufacturers storage

recommendations should be strictly
adhered to. Refer to relevant instruc-
tions.

1.4 

Care and cleaning

• Before maintenance, switch off the ap-

pliance and disconnect the mains plug
from the mains socket.

• Do not clean the appliance with metal

objects.

• Regularly examine the drain in the re-

frigerator for defrosted water. If neces-
sary, clean the drain. If the drain is
blocked, water will collect in the bot-
tom of the appliance.

1.5 

Installation

For electrical connection careful-
ly follow the instructions given in
specific paragraphs.

• Unpack the appliance and check if

there are damages on it. Do not con-
nect the appliance if it is damaged.
Report possible damages immediately
to the place you bought it. In that case
retain packing.

• It is advisable to wait at least four

hours before connecting the appli-
ance to allow the oil to flow back in
the compressor.

• Adequate air circulation should be

around the appliance, lacking this
leads to overheating. To achieve suffi-
cient ventilation follow the instructions
relevant to installation.

• Wherever possible the back of the

product should be against a wall to
avoid touching or catching warm parts
(compressor, condenser) to prevent
possible burn.

• The appliance must not be located

close to radiators or cookers.

• Make sure that the mains plug is ac-

cessible after the installation of the ap-
pliance.

• Connect to potable water supply only

(If a water connection is foreseen).

1.6 

Service

• Any electrical work required to do the

servicing of the appliance should be
carried out by a qualified electrician or
competent person.

• This product must be serviced by an

authorized Service Centre, and only
genuine spare parts must be used.

18 www.aeg.com