English
47
Remote control
NOTE:
The lithium cell in the battery compartment of the remote
control was secured with foil for transport. This extends the
battery life. Remove this foil before initial use to operate the
remote control.
For wireless operation from a distance of up to 5 meters. Dur-
ing operation, please ensure a clear line of view between the
remote control and the sensor (13) on the device. If this range
should diminish, the battery must be replaced. Replace the
battery as follows:
1. Open the battery compartment.
2. Replace the cell with a battery of the same type (CR
2025). Please observe the correct polarity.
3. Close the battery compartment.
WARNING:
• Do not expose the batteries to intense heat such as
sunlight, fire or similar. There is a
risk of explosion!
• Keep batteries away from children! They are not a toy.
• Do not open batteries with force.
• Avoid contact with metallic objects (rings, nails, screws,
etc.). There is a risk of short circuit!
• Batteries may heat up considerably through a short
circuit or may even ignite. It could result in burns.
• The battery terminals should be covered with adhesive
tape during transport for your safety.
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• If a battery does leak out, do not rub the liquid into your
eyes or the mucous membranes. In case of contact,
wash your hands, rinse your eyes with clear water, and if
the symptoms persist, consult a doctor.
CAUTION:
• Batteries can leak out and can lose battery acid. If the
device is not used for a longer period of time, remove
the battery from the remote control.
• Batteries do not belong in the household waste. Please
dispose of spent batteries at authorized collection
points or at the dealer.
Transport Safety Device, CD Compartment
• Open the CD tray (6) by pressing the PUSH TO OPEN
button (7).
• Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Reset to factory defaults
Important! All radio stations saved previously will be lost.
1. Turn off the device using the STANDBY button.
2. Press and hold the
/ button for approx. 5 seconds.
The device will be reset to factory defaults.
General operation
NOTE:
• You will find some buttons both on the device and
the remote control. Identical buttons have the same
function.
• The operation of the device is described by the buttons
on the device.
Turning device on / off
• Press the STANDBY button (17) to turn the device on.
• To turn off the device, press the STANDBY button
again. The control lamp STANDBY (13) lights up red.
NOTE:
After about 15 minute without a signal, the device will
automatically switch to standby.
Volume
You can adjust the desired volume with the VOLUME control
(18).
FUNCTION (11)
Press the FUNCTION button until the desired operating
mode is shown in the display.
EQ/ID3 (4)
• Press the EQ/ID3 button repeatedly to select one of the
preset equalizer sound modes. You may choose from the
following: (FLAT, ROCK, POP, JAZZ, CLASSIC).
• Press and hold the button briefly during MP3 playback in
order to turn the ID3 tag metadata on or off.
LIGHT (16)
Repeatedly press the LIGHT button to select a lighting mode
for the front speakers. Selecting “LIGHT OFF” will deactivate
this function.
Headphone jack (3)
For headphone operation, use headphones with a 3.5 mm
jack plug that you plug into the headphone jack of the
device. The loudspeakers will be shut off.
MUTE (1 on the remote control)
You can quickly shut off the sound using the MUTE button.
The notification “MUTE” will blink in the display. Press the
button again to turn the sound back on.
