AEG SWE66001DG, User Manual

It must be possible to

disconnect the appliance

from the mains power

supply. The plug must

therefore be easily

accessible after installation.

3.3 Electrical Connection

CAUTION!

Any electrical work required

to install this appliance

should be carried out by a

qualified electrician or

competent person.

WARNING!

This appliance must be

earthed.

The manufacturer declines

any liability should these

safety measures not be

observed.

The wires in the mains lead are coloured

in accordance with the following code:

A

B

C

D

E

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains

lead of this appliance may not

correspond with the coloured markings

identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and

yellow to the terminal marked either

with the letter “E“ or by the earth

symbol   or coloured green and

yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter

“N“ or coloured black.

3. Connect the wire coloured brown to

the terminal either marked with the

“L“ or coloured red.

4. Check that no cut, or stray strands of

wire is present and the cord clamp

(E) is secure over the outer sheath.

Make sure the electricity supply

voltage is the same as that indicated

on the appliance rating plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp

fuse (B). In the event of having to

change the fuse in the plug supplied, a

13 amp ASTA approved (BS 1362) fuse

must be used.

WARNING!

A cut off plug inserted into a

13 amp socket is a serious

safety (shock) hazard.

Ensure that it is disposed of

safely.

3.4 Levelling

When placing the appliance make sure

that it stands level. This can be achieved

by two adjustable feet at the bottom in

front.

3.5 Installing the upper

bracket

Fasten your appliance:
• Use two screws to install the upper

bracket on the top of the appliance.

• Put the appliance in the cupboard and

use two screws to fix the upper

bracket on the cupboard.

www.aeg.com

8