AEG T7DBTRIPLE, User Manual

8.9 

Program change

To change a program:

1.

Push the Aan/Uit button to turn the

appliance off.

2.

Push the Aan/Uit button again to turn

on the appliance.

3.

Set a new program.

8.10 

Program end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle is finished, the symbol

 appears on the display. If the Zoemer

option is activated, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the anti-crease

phase starts (not active with
all programs). Flashing 

symbol signals the execution

of the anticrease phase.

Laundry can be removed

during this phase.

To remove the laundry:

1.

Push the Aan/Uit button for 2

seconds to turn the appliance off.

2.

Open the appliance door.

3.

Remove the laundry.

4.

Close the appliance door.

9. 

HINTS AND TIPS

9.1 

Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programs chapter.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• Use distilled water like that used for

steam ironing. If it is necessary, clean

the distilled water before (e.g. with a

coffee filter) to remove any particles.

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

9.2 

Adjustment of default

dryness level

To change the default dryness level:

1.

Turn the appliance on.

2.

Wait approximately 8 seconds.

3.

Select 1 of the available

programmes.

4.

Touch and hold down the 

Droogtegraad

 and 

Anti-kreuk

buttons at the same time.

One of the symbols appears on the

display:

 - Maximum dryness

 - Extra dryness
 - Standard dryness

5.

Touch the 

Start/Pauze

 button

repeatedly until you reach the

desired dryness level.

Dryness lev-

el

Display symbol

Maximum
dryness

Extra dry-
ness

Standard
dryness

6.

To memorise the setting touch and

hold down the 

Droogtegraad

 and 

Anti-kreuk

 buttons at the same time

for approximately 2 seconds.

9.3 

Deactivating the tank

indicator 

The water container indicator is activated

by default. It illuminates at the end of the

drying cycle or during the cycle if the

water reservoir is full. If the draining kit is

installed the water container is drained

ENGLISH

15