10.3
Cleaning the condenser
If the symbol
Condenser
flashes on
the display, inspect the condenser and
its compartment. If it is dirty, clean it. Do
the check not less than once a 6 months.
WARNING!
Do not touch the metal
surface with bare hands. Risk
of injury. Wear protective
gloves. Clean carefully to
avoid damaging the metal
surface.
To inspect:
1.
Open the door. Pull the filter up.
2.
Open the condenser cover.
3.
Turn the lever to unlock the
condenser lid.
4.
Lower the condenser lid.
5.
If necessary, remove the fluff from
the condenser and its compartment.
You can use a wet cloth and/or a
vacuum cleaner with a brush
attachment.
6.
Close the condenser lid.
7.
Turn the lever until it clicks into
position.
8.
Put the filter back.
10.4
Cleaning the humidity
sensor
CAUTION!
Risk of humidity sensor
damage. Do not use
abrasive materials or steel
wool to clean the sensor.
To assure best drying results the
appliance is equipped with metal
humidity sensor. It is placed on the inner
side of the door area.
Over usage time the surface of the
sensor may get dirty what deteriorates
the drying performance.
We recommend to clean the sensor at
least 3 or 4 times or if you observe the
drop of drying performance.
ENGLISH
19
Summary of Contents for T8DER945C
Page 1: ...USER MANUAL EN User Manual Tumble Dryer T8DER945C ...
Page 29: ...ENGLISH 29 ...
Page 30: ...www aeg com 30 ...
Page 31: ...ENGLISH 31 ...