AEG T8DHC846B, User Manual

3.

Touch and hold down 2 buttons at

the same time.

The symbol   appears on the display.

4.

To deactivate the child lock, touch

the above buttons again until the

symbol disappears.

9.8 

Starting a program

4

To start the program:
Touch the 

Start/Pause

 button.

The appliance starts and the LED above

the button stops flashing and stays on.

9.9 

Program change

To change a program:

1.

Push the On/Off button to turn the

appliance off.

2.

Push the On/Off button again to turn

on the appliance.

3.

Set a new program.

9.10 

Programme end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle is finished, the symbol

 appears on the display. If the Buzzer

option is activated, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the anti-crease

phase starts (not active with
all programmes). Flashing 

symbol signals the execution

of the anti-crease phase.

Laundry can be removed

during this phase.

To remove the laundry:

1.

Push the On/Off button for 2

seconds to turn the appliance off.

2.

Open the appliance door.

3.

Remove the laundry.

4.

Close the appliance door.

Possible causes of unsatisfactory drying

results:
• Inadequate default dryness level

settings. See chapter 

Adjustment of

default dryness level

• Room temperature is too low or too

high. Optimal room temperature is

between 18°-25°C.

10. 

HINTS AND TIPS

10.1 

Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programs chapter.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• The water from the water container

can be used to iron the clothes. You

must first filter the water to eliminate

remaining textile fibres (simple coffee

filter is suitable).

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

www.aeg.com

16