5.2 Over-the-air update
The App may propose an update for downloading new features.
The update is accepted via App only.
If a programme is running, the App notifies that the update will start
at the end of the programme.
During the update, the appliance shows
in the display.
The appliance will usable again at the end of the update, without
any notification about successful update.
If an error occurs, the appliance shows
in the display: just
press any buttons or turn the knob to return to normal use.
5.3 Wireless connection configuration
Before you begin configuration download and install My AEG
application on your smart device.
1. Push the On/Off button to switch on the appliance.
2. Wait approximately 8 seconds.
3. Touch and hold down the Refresh and Delay Start buttons at the
same time.
The symbols: and appear on the display. After few seconds
remains only flashing symbol: . Wireless module is activating
around 1 minute. When ready the symbol: (Access Point)
appears on the display. Access Point is open around 3 minutes.
4. Configure My AEG application on your smart device.
If the configuration is successful the symbol: (Access Point)
disappears and the symbol: stops flashing.
Each time you switch the appliance on, the appliance attempt to
connect to the network automatically. When the connection is
established the symbol: stops flashing.
18/60
WI-FI - CONNECTIVITY SETUP
Downloaded from www.vandenborre.be