Error code
Possible cause
Remedy
E50
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
E90 or E91
Internal fail. No communication be‐
tween electronic elements of the
appliance.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
EH0
The mains supply is unstable.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
Possible cause
Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connected
to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
The door is open.
Close the door.
The Zap./Vyp. button was not
pushed.
Push the Zap./Vyp. button.
The Start/Pauza button was not
touched.
Touch the Start/Pauza button.
The appliance is in standby mode. Push the Zap./Vyp. button.
www.aeg.com
24
Summary of Contents for TR938H2C
Page 1: ...USER MANUAL EN User Manual Tumble Dryer TR938H2C ...
Page 33: ......
Page 34: ......
Page 35: ......