AEG UZ 930S, Instructions For Use Manual

8

Please read these essential instructions

 (Only applicable to UK)

UZ 930S/S2 are designed, developed and rigo-
rously tested to function efficiently and safely
when properly maintained and used in accordan-
ce with the following instructions. These instruc-
tions have been prepared with safety and effi-
ciency paramount.
The MACHINE OPERATOR must be trained by
a suitably qualified instructor, and be made awa-
re of the relevant regulations and legislation
currently in force at the time of use.

CAUTION - This machine MUST NOT be used in
explosive or inflammable atmospheres or where
such atmospheres are likely to be produced by
the presence of volatile liquid or inflammable gas
or vapour.

CAUTION - In no circumstances should the
power supply cord be wrapped around fingers or
any part of the operators person.

CAUTION - The electrical supply plug must not
be subjected to undue stress by pulling on the
power supply cord.

Your MACHINE must only be connected to an
electrical supply of the same voltage and frequency
as indicated on the rating plate. Ensure that the plug
fitted to the end of the power supply cord is suitable
for your supply socket, if not refer to the information
contained in 'Electrical Connections', or consult a
qualified electrician. The electrical installation from
which the supply is drawn must be maintained to
current Institute of Electrical Engineers wiring regu-
lations.

REGULAR SERVICING and INSPECTION of your
machine must be carried out by suitably qualified
personnel in accordance with relevant legislation
and regulations. In particular, electrical tests for
earth continuity, insulation resistance, and condi-
tion of the flexible cord should be checked frequent-
ly. In the event of any defect the machine MUST be
withdrawn from service, completely checked and
repaired.
Trained Service Engineers will be pleased to carry
out on site servicing on a regular or as requested
basis, to ensure the continuing safety and efficiency
of your machine.