5
ENGLISH
4. CONTROLS
Button
Function
Led
A
Changes the intensity of the Lighting each time
the Button is pressed, in cycle, passing via Off.
-
B
Motor off.
The Leds indicating the Speed of the motor
turn off.
Enables / Disables Keyboard Lock mode if pres-
sed and held for 5 seconds.
All the Leds light up in cycle and run a
start-up sequence.
C
Activates speed one.
The Leds indicating Speed one and Motor
Off turn on.
D
Activates speed two.
The Leds indicating Speed two and Motor
Off turn on.
E
Activates the speed Intensive 1. This speed is ti-
med to run for 10 minutes. At the end of this time
the system will return to the speed set previously.
It is disabled by pressing the Button or turning the
Motor off.
The LED lashes.
F
Activates the speed Intensive 2. This speed is
timed to run for 8 minutes. At the end of this time
the system will return to the speed set previously.
It is disabled by pressing the Button or turning the
Motor off.
The LED lashes.
G
Activates / Deactivates Delay mode, with automa-
tic shutdown of the Motor and the Lighting after
15 minutes. It is disabled by pressing the button
or turning the motor off.
The Led lights up.
Pressing and holding the button for 5 seconds
enables the remote control and the H2H function.
Pressing and holding the button for 5 seconds
disables the remote control and the H2H function.
2 lashes from Leds on Buttons B+C.
1 lash from Leds on Buttons B+C.
H
With the ilter alarm triggered, press the button to
Reset the alarm. These indications are only visible
when the motor is turned off.
When the procedure terminates, the indica-
tion shown previously turns off:
Led H on = Indicates the need to wash the
metal grease ilters. The alarm is triggered
after the Hood has been in operation for
100 working hours.
Led H lashing = Indicates the need to
change the activated charcoal ilters, and
also to wash the metal grease ilters. The
alarm is triggered after the Hood has been
in operation for 200 working hours.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
on/off.
2 lashes from Leds on Buttons B+H = A.C.
ilter alarm activated.
1 lash from Leds on Buttons B+H = A.C.
ilter alarm deactivated.
Summary of Contents for X09481BV-X
Page 39: ...39 ITALIAN Pulire la cappa utilizzando un panno umido e un detergente liquido neutro ...
Page 170: ......
Page 171: ......
